Side Sill Seal, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the seal must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.
-- Clean the adhesive surface on the side sill using the Cleaning Solution:D 009 401 04 .
-- Apply Bonding Agent:D 355 205A2 on the adhesive surface of the side sill using the Applicator:D 009 500 25 and let dry.
-- Attach the side sill seal -1- on the side sill -2- with the pins -arrow A-.
-- Push the side sill seal onto the side panel flange -C arrows-.
-- Remove the peel-off backing -3- from the tape.
-- Mount the side sill seal on the side panel with the pins -B arrows- and then bond.