Overview - Door Seals
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Side Sill Seal
- Removing and Installing. Refer to SIDE SILL SEAL, REMOVING AND INSTALLING .
- Inner Door Seal
- Removing and Installing. Refer to INNER DOOR SEAL, REMOVING AND INSTALLING .
- Outer Door Seal
- Replace after removing.
- Installation position. Refer to Fig 4.
- Removing and Installing. Refer to OUTER DOOR SEAL, REMOVING AND INSTALLING .
- C-Pillar Seal
- Installation position. Refer to Fig 3.
- B-Pillar Seal
- Installation position. Refer to Fig 2.
- Seam Seal
- Removing and Installing. Refer to SEAM SEAL, REMOVING AND INSTALLING .
B-Pillar Seal Installation Position
- The vehicle and the seal must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Apply Bonding Agent:D 355 205A2 on the adhesive surface using the Applicator:D 009 500 25 and let dry.
-- Remove the protective film, put the seal in the installation position and apply it.
- Seal
- Inner Door Panel
- Outer Door Panel
C-Pillar Seal Installation Position
-- Bring the seal into the installation position.
- Seal
- Outer Door Panel
- Inner Door Panel
Outer Door Seal Installation Position
- Door Body
- Seal