Overview - Door
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Door
- Removing and Installing. Refer to DOOR, REMOVING AND INSTALLING .
- Hinge
- Upper
- Bolt
- 50 Nm
- Set Screw
- 27 Nm
- Cap
- Nut
- Quantity: 2
- 32 Nm
- Cap
- For the door arrester
- Installation position. Refer to Fig 1.
- Bolt
- Quantity: 2
- Replace after removing
- 8 Nm
- Door Arrester
- Installation position. Refer to Fig 2.
- Removing and Installing. Refer to DOOR ARRESTER, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 33 Nm
- Bolt
- 32 Nm
- Hinge
- Lower
- Bolt
- 32 Nm
- 28 Nm when using the following special tools. Refer to SIDE AND LENGTH ADJUSTMENT AT HINGE .
Cap Installation Position
In the installed position, the lettering on the cap -1- must be readable in the upper installation position.
2 - LEFT UPPER REAR - left / RIGHT UPPER REAR - right
3 - HL - left / HR - right
Door Arrester Installation Position
In the installed position, the lettering on the door arrester -1- must be readable in the upper installation position:
2 - HL - left / HR - right