Impact Member, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Install the impact member in the sequence: -1 through 5-.
| Step | |
|---|---|
| 1. | -- Insert the impact member into the door. |
| 2. | -- Tighten the screw -4- to 1.5 Nm. |
| 3. | -- Insert the member plate -2- and tighten the screw -1-. |
| 4. | -- Tighten the screws in the following sequence: -4, 5 and 6-. |
| 5. | -- Press on the cover -7- and cap -3- until they audibly lock. |