Near Field Communication Antenna 2 -R351-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Using the Release Tool:T40388 -A-, carefully push the rubber lip on the Near Field Communication Antenna 2 -R351- to the side and guide in the release tool vertically from above as shown.

Courtesy of AUDI

-- The catch -2- is released and engages in the groove on the release tool -A-.

-- Pull the release tool -A- back out vertically upward and remove the Near Field Communication Antenna 2 -R351- -1- from the storage compartment.

-- The Near Field Communication Antenna 2 -R351- is attached to the opposite side. Tilt the Near Field Communication Antenna 2 -R351- -1- out of the storage compartment.

-- Release and disconnect the connectors from the Near Field Communication Antenna 2 -R351- -1-.