Coolant Shut-Off Valve -N82-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following.
TIP
- Since only a small amount of coolant flowed out of the coolant circuit when removing the Coolant Shut-Off Valve -N82- as described above, the coolant flows into Coolant Shut-Off Valve -N82- after installing and removing the hose clamps (additionally opening the coolant expansion tank cap).
- The shut-off valve -A- is secured to the noise insulation via the rubber bushing -L- (with bearing bushings and washers) the nuts -G- and the bolts -F- on the bracket -K-.
-- Check the rubber bushing -L- is seated correctly in the bracket -K-.
-- Drain and fill the coolant circuit. Refer to COOLANT, DRAINING AND FILLING - DMSA or COOLANT, ADDING AND COOLING SYSTEM, BLEEDING, HIGH-VOLTAGE SYSTEM COOLING CIRCUIT - DPVA or COOLANT, DRAINING AND FILLING - EA839 .
Tightening Specification
| Component | Tightening Specification |
|---|---|
| Coolant Shut-Off Valve -N82- on the bracket | 8 Nm |
| Bracket for the Coolant Shut-Off Valve -N82- on the plenum chamber | 8 Nm |