CLUTCH PLATE, REMOVING AND INSTALLING, A/C COMPRESSOR "Sanden" (WITH A/C Clutch -N25-): Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Clean the contact surfaces on the clutch plate and belt pulley before attaching.
-- Clean the A/C compressor shaft threads before attaching the clutch plate.
-- Tighten the nut -A-.
-- After tightening the nut, check the gap dimension between the belt pulley and clutch plate and correct it if necessary. Refer to GAP DIMENSION BETWEEN BELT AND CLUTCH PLATE, CHECKING, "Sanden" A/C COMPRESSOR (WITH A/C Clutch -N25-) .