BELT PULLEY, REMOVING, WITH A/C Clutch -N25-
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Mount the arms on the puller so that the outside of the belt pulley does not get bent if the belt pulley -A- is going to be used again.
- If the belt pulley -A- (after removing the circlip) cannot be removed from the A/C compressor flange by hand (for example because of debris), carefully remove the belt pulley as described below.
-- Remove the belt pulley -A- with a puller (three arm) -B- while noting the following.
- Do not support the puller spindle -B- on the A/C compressor shaft when removing the belt pulley -A-.
- Use a sleeve -C- (for example, Sleeve VAG 1719/1 taken from A/C Clutch Set:VAG1719 ) to support the spindle on the arm puller -B- on the A/C compressor flange.
-- Clean the flange on the A/C compressor thoroughly after removing the belt pulley -A-. It must possible to install the belt pulley -A- by hand.