BELT PULLEY (WITHOUT A/C Clutch -N25-), REMOVING AND INSTALLING, A/C COMPRESSOR "Sanden" MANUFACTURER
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- The belt pulley is made of plastic and is sensitive to impact, therefore be especially careful when handling it.
- If the belt pulley overload protection is triggered, then the A/C compressor must be checked for ease of movement before replacing the belt pulley. If the A/C compressor is difficult to move, this must be replaced completely.
- If the drive plate overload protection was activated, the belt pulley can be rotated using the outer part of the drive plate so that the A/C compressor shaft and the hex fitting on the drive plate (inner part of the drive plate) do not rotate.
-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING - DMSA or RIBBED BELT, REMOVING AND INSTALLING - DPVA or RIBBED BELT, REMOVING AND INSTALLING - EA839 .
-- Belt Pulley, Removing and Installing. Refer to OVERVIEW - BELT PULLEY, "Sanden" A/C COMPRESSOR .