Valve, Removing And Installing, Rubber Valve
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure wheel rim is clean.
-- Using the Valve Fitting Tool:VAS6459 -1-, insert a new tire valve.
-- Remove the valve insert.
-- Inflate the tire to approximately 3 to 4 bar (43.51 to 58.02 psi); the tire bead must slip audibly over the rim hump when doing this.
-- Install the valve insert.
-- Fill the tire to the specified pressure.
CAUTION:
Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.
-- Balance the tire.