Valve, Removing And Installing, Metal Valve: Installing
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only apply the specified torque to tighten the nut for the metal valve.
Tightening more is not permitted because it damages the seal.
-- Tighten the nut -1- of the metal valve.
-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.
-- Install the Tire Pressure Monitoring Sensor --.
-- Fill the tire to the specified pressure.
CAUTION:
Do not screw any aluminum valve caps onto steel valve bodies. Aluminum caps attach to the steel valve body into a inseparable connection and cannot be separated again.