Component Location Overview - Seat Occupant Detection System
WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
For the Seat Heating Element Is Used for the Seat Occupant Detection System.
- Wiring Harness
- For the seat heating element with seat occupant detection system
- Connector station in the underbody under the seat.
- Refer to Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING
- Nut
- 1.5 Nm
- Front Passenger Seat Heating Element with Passenger Occupant Detection System Control Module -ZX14-
- Market-Specific Version
- The seat heating element is used for the seat occupant detection system
- With Front Passenger Seat Heating Element -Z8- and Passenger Seat Occupant Detection Sensor -G128-
- Depending on the seat version, the Passenger Seat Occupant Detection Sensor -G128- is either sewn into the cover with the seat heating element, or bonded onto the cushion
- Refer to Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING
- Front Passenger Seat Position Sensor -G554-
- Driver seat: Driver Seat Position Sensor -G553-
- Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
- Bolt
- Tightening Specification. Refer to -item 6- OVERVIEW - SEAT POSITION SENSOR.
- Wiring Harness
- For the seat position sensor/seat belt fastening detection/seat belt switch
- Connector station in the underbody under the seat.
- Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
- Seat Occupant Detection System Control Module -J706-
Control Module Tightening Specification on Bracket - Standard seat
-- Tighten the screws -2- to 1.5 Nm.