Front Passenger Airbag Unit With Igniter, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Replace the connector for the Front Passenger Airbag Release Valve Igniter -N491- after an airbag has deployed. Refer to WIRING HARNESSES AND CONNECTORS, REPAIRING .

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Connect the connector -1- to the airbag igniter in direction of -arrow A-.

Courtesy of AUDI

-- Press in the connector lock -2- in the direction of -arrow B-. At the same time, the connector is pushed into the airbag igniter all the way and locks into place.

Make sure the wires are not pinched.

CAUTION:

Risk of airbag deployment.

Risk of injury.

- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.

-- Check and erase the airbag control module DTC memory because faults can be stored from when the connectors are disconnected. Use the Vehicle Diagnostic Tester.