Luggage Compartment Cover Drive Unit -VX68-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Roll Cover Motor Nuts And Bolt Tightening Sequence

Courtesy of AUDI

-- Remove the luggage compartment floor. Refer to LUGGAGE COMPARTMENT FLOOR, REMOVING AND INSTALLING .

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the luggage compartment side trim panels. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connector -arrow-.

-- Slightly lift the left and right supports for the luggage compartment floor.

-- Remove the nuts -1- and bolt -2-.

-- Remove the nut -2- and bolts -3 and 4-.

Courtesy of AUDI

-- Unclip the release cables from the brackets -arrows-.

-- Repeat the procedure on the opposite side.

-- Disengage and remove the guide rails -1- with the roll cover motor.