Luggage Compartment Cover Drive Unit -VX68-, REMOVING AND INSTALLING: Installing

Courtesy of AUDI

-- Attach the guide rails -1- with the roll cover motor.

-- Attach the guide rail -1- with bolts -3 and 4- and nut -2-, but do not tighten.

-- Repeat the procedure on the opposite side.

-- Tighten the nuts and bolt in the sequence -1 and 2- on the roll cover motor.

Fig 1: Roll Cover Motor Nuts And Bolt Tightening Sequence

Courtesy of AUDI

-- Connect the connector -arrow-.

-- Tighten the bolts and nut to the guide rail -1- in the sequence -2, 3 and 4-.

Courtesy of AUDI

-- Clip the release cables for the guide rail to the brackets -arrows-.

-- Repeat the procedure on the opposite side.

-- Install the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Clip both carriers for the roll cover -2- into the guide rail and secure with an expander pin -1-.

Courtesy of AUDI

-- Perform a function test after installation.

-- Check if both roll cover carriers -2- at the top and bottom are parallel to each other at the stop in the luggage compartment side trim panel guide.

-- If the catches are not parallel, check the routing of the release cable and/or adjust the release cables.

Release Cables for the Roll Cover, Adjusting

Fig 2: Turning Upper Section -1- In Direction Of -Arrow A- Or -Arrow B- When Adjusting

Courtesy of AUDI

-- Turn the release cable adjuster -1- in the direction of -arrow A- or -arrow B-.

-- Adjust the release cable so that both of the roll cover catches are parallel to each other.

Further installation is performed in reverse order of the removal.