LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Interior Equipment) >> 68 Interior Equipment >> Center Console >> Center Console, Removing And Installing >> Removing

Center Console, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
GWWA68-10818Courtesy of AUDI

-- Remove the center console cover. Refer to CENTER CONSOLE COVER, REMOVING AND INSTALLING .

-- Remove the front footwell center console trim panel. Refer to FRONT FOOTWELL CENTER CONSOLE TRIM PANEL, REMOVING AND INSTALLING .

-- Disengage the left and right carpet from the center console support.

-- To remove the expanding clips -1-, push the clamping pin -2- in carefully approximately 5 mm until it engages audibly in the expanding clip in the direction of -arrow- (do not push in completely, otherwise the clamping pin will be lost).

-- Unclip the wiring harnesses and free it up.

GWWA68-10717Courtesy of AUDI

-- If equipped: remove the air duct intermediate piece for the rear center console vent. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .

-- Remove the bolts -1, 4, 5, 6 and 7- and nuts -2 and 3-.

-- Lift up the center console support from the threaded pin and remove it toward the rear.