Vacuum Pump, Removing And Installing, Vehicle With 3.0L TFSI Engine: Installing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Check the vacuum hose for damage before assembling and replace if necessary.
Secure all hose connections with hose clamps. Refer to the => Parts Information.

-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning in direction of -arrows-.

Fig 1: Position Vacuum Pump Yoke

Courtesy of AUDI OF AMERICA, LLC

-- Push the new hose clamp over the vacuum hose.

-- Install the vacuum hose with the hose clamp -1- connected.

Fig 2: Locating Hose Clamp -1-

Courtesy of AUDI OF AMERICA, LLC