Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K0 AND 0K3 .

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING - 2.0L DMSA , AIR FILTER HOUSING, REMOVING AND INSTALLING - 2.0L DPVA AIR FILTER HOUSING, REMOVING AND INSTALLING - 3.0L or AIR FILTER HOUSING, REMOVING AND INSTALLING - 3.0L .

-- Release the retainer in the direction of -arrow-.

Courtesy of AUDI

-- Open the cover -1-.

-- If equipped, remove Terminal 30 Wire Junction -TV2- -2- and move to the side with the wires still connected. Refer to Terminal 30 Wire Junction 2 -TV22- .

Courtesy of AUDI

-- Disconnect the connector -5-.

-- Remove the nuts -2 and 3- and free up the wires -1 and 4-.

-- Free up the wiring harness -arrow-.

-- Remove the bolts -arrows-.

Courtesy of AUDI

-- Free up the connector -3- and disconnect the connector -2-.

-- Remove the wire junction -1-.