Component Location Overview - Relay Panel, Instrument Panel, E-Boxes Engine Compartment
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the control modules
- Nut
- Quantity: 2
- 2.5 Nm
- Automatic Glow Time Control Module -J179-
- Removing and Installing. Refer to the appropriate Service Information. .
- Bolt
- 2.5 Nm
- Positive Cable
- To starter, generator
- Nut
- 18 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Tightening specification: 7.5 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Tightening specification: 7.5 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Tightening specification: 7.5 Nm
- Line
- Allocation. Refer to the appropriate Wiring Diagram.
- Tightening specification: 7.5 Nm
- Terminal 30 Wire Junction 2 -TV22-
- Removing and Installing. Refer to Terminal 30 Wire Junction 2 -TV22- .
- Nut
- 7.5 Nm
- Bolt
- Quantity: 2
- 7.5 Nm
- Nut
- 18 Nm
- Positive Cable
- From the battery
- Terminal 30 Wire Junction -TV2-
- Removing and Installing. Refer to Terminal 30 Wire Junction -TV2-, REMOVING AND INSTALLING .
- Suppressor -C24-
- Removing and Installing. Refer to Suppressor -C24-, REMOVING AND INSTALLING .
- Cap
- Relay and Fuse Panel 3 -SR3-
- Allocation. Refer to the appropriate Wiring Diagram.