Right A-Pillar Connector Station, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K0 AND 0K3 .
-- Remove the right front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Push the carpet in the connector station area as far as possible to the side.
-- Disconnect the connector -1-.
-- If equipped, disconnect and free up the wire -3- and the antenna wires -4 and 5-.
-- Pry out the connector station -2- from the body.
-- Release the retainer -3- in the direction of -arrow- and push the connector terminal -2- out of the bracket -1-.