Refrigerant, Handling
If refrigerant canisters are opened, the contents may escape in liquid or vapor form. This intensifies the higher the pressure in the canister.
The pressure level is dependent on two factors:
- The type of refrigerant in the canister. "Reason: the lower the boiling point, the higher the pressure."
- The temperature level. "Reason: the higher the temperature, the higher the pressure."
- There is a risk of freezing.
- The refrigerant can then escape as a fluid or vapor.
- Do not open canisters that contain refrigerant.
Wear protective eyewear.
Put on protective eyewear. They prevent refrigerant getting into the eyes, as this could cause severe injury from exposure to cold.
Safety Gloves and Apron
Greases and oils dissolve readily in refrigerants. They would therefore destroy the protective layer of grease if allowed to come into contact with the skin. Degreased skin is however sensitive to the cold and germs.
Fluid Refrigerant, Avoiding Contact with Skin
The refrigerant draws heat for evaporation from the surrounding area. Even if this is the skin. This may cause extremely low temperatures. Frost bite may result at the point of contact (boiling point of R134a: -26.5 °C (-15.7 °F) at ambient pressure).
Do not breathe in the refrigerant vapors
If highly concentrated refrigerant vapor escapes, it mixes with the surrounding air and displaces the oxygen necessary for breathing.
No Smoking Rule
A burning cigarette can cause refrigerant to decompose. The resulting substances are toxic and must not be inhaled.
Welding and Soldering on Refrigeration Systems
Before performing welding or soldering work on vehicles near A/C system components, extract the refrigerant and remove remnants by blowing them out with nitrogen.
The products of refrigerant decomposition due to the effect of heat are not only toxic, but may also have a highly corrosive effect on pipes and system components. They mainly take the form of hydrogen fluoride.
Pungent odor
A pungent odor indicates that the products of decomposition mentioned above have already formed. Avoid inhaling these substances under all circumstances, as otherwise the respiratory system, lungs and other organs could be damaged.
First Aid
- If contact with eyes or mucous membranes occurs, immediately rinse with copious amounts of running water and consult an eye specialist.
- If contact with the skin occurs, immediately remove affected clothing and rinse skin with copious amounts of water.
- If inhalation of highly concentrated refrigerant vapors occurs, immediately take the affected person(s) into the fresh air. Call a doctor. Administer oxygen in the event of breathing difficulties. If the affected person has difficulty breathing or cannot breathe, tip head back and perform mouth to mouth respiration.