Rear Lid, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear lid upper trim panel. Refer to REAR LID UPPER TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connectors -arrows-.
-- Release and disconnect the washer fluid hose connection -2-.
-- Remove the bolts -4-.
-- Free up the wiring harness -1 and 3-.
-- Guide the wiring harnesses -1 and 3- with the rubber grommet -5- out of the rear lid.
-- Lift the locking spring -2- slightly with a small screwdriver -arrow- and Rear Lid Motor 1 -V444- /Rear Lid Motor 2 -V445- -item 1- from the rear lid ball pin.
-- Remove the left and right bolts -2-.
-- Remove the rear lid -1-.