LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Hood, Lids) >> 55 Hood, Lids >> Fuel Filler Door Unit >> Fuel Filler Door Unit, Removing And Installing >> Removing

Fuel Filler Door Unit, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the luggage compartment side trim panel and free up the emergency release cable. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Detach the rear section of the right wheel housing liner and push it aside. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Free up the drain hose -1- -arrows-.

GWWA55-11211Courtesy of AUDI

-- Remove the fuel filler door unit trim. Refer to FUEL FILLER DOOR UNIT TRIM, REMOVING AND INSTALLING .

-- Release the fuel filler door unit by using a small screwdriver to pierce the markings -arrows-.

GWWA55-10885Courtesy of AUDI

-- At the top of the fuel filler door unit, pierce a small screwdriver through the markings -arrows- at an angle from below into the fuel filler door through the retainers.

GWWA55-10886Courtesy of AUDI

-- Gently lift the screwdriver upward and release the retainers.

-- On the underside, pierce the screwdriver at the markings at an angle from above to below.

-- Gently push the screwdriver downward and release the retainers.

-- Remove the fuel filler door unit with the drain hose gradually from the opening.

-- Disconnect the connector.

-- Remove the fuel filler door unit while guiding out the emergency release cable.