LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 322 (Hood, Lids) >> 55 Hood, Lids >> Charge Door Unit >> Charge Door Unit, Removing And Installing >> Removing

Charge Door Unit, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the luggage compartment left trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Disengage the handle for the emergency release cable and free it up.

-- Open the charge door unit.

-- Remove the charging socket cap.

-- Grab behind the wheel housing liner and push the grommet -2- for the drain hose -1- inward.

GWWA55-11298Courtesy of AUDI

-- Release the charge door unit at the markings -arrows- pierce using a small screwdriver at the markings.

GWWA55-11322Courtesy of AUDI

-- Upper catch: position a screwdriver over the catch -1- and release with the screwdriver -arrow A-.

GWWA55-11310Courtesy of AUDI

-- Lower catch: position a screwdriver under the catch -3- and release with the screwdriver -arrow B-.

-- Close the charge door unit.

-- Remove the charge door unit from the opening in the body.

-- Disconnect the connectors -1 and 2-.

GWWA55-11323Courtesy of AUDI

-- Remove the charge door unit at the same time guide out the emergency release cable -3-.