Terminal 30a Wire Junction -TV3-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable to the Battery -A- when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING .

On vehicles with 48 volt system (PR number VH2/VH3) must be de-energized before the 48 V system. Refer to 48V SYSTEM, DE-ENERGIZING .

-- Release the retainers -arrows-.

Courtesy of AUDI

-- First open cover -2- and then cover -1-.

-- Remove the wires -2 and 5- and free them up.

Fig 1: Digital Sound System Control Module Connector End View (J525, T38, T18i, T2ca)

Courtesy of AUDI

-- Remove the nut -6-.

-- Release the retainers -arrows- and remove the wire junction -1-.