MAIN FUSE PANEL ON Battery -A-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable to the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

On vehicles with 48 volt system (PR number VH2/VH3) must be de-energized before the 48 V system. Refer to 48V SYSTEM, DE-ENERGIZING .

-- Open the cover -1- over the battery positive terminal.

Fig 1: Battery Ground Cable Connector With Bolt

Courtesy of AUDI

-- Loosen the nut -3- several turns and remove the battery positive cable terminal clamp -2- from the battery terminal.

-- Release the catch -3- and open the flap -2- above the main fuse panel -1- -arrow-.

Fig 2: Fuse Box Cover, Removal

Courtesy of AUDI

-- Remove the wires -1, 2, 4, 5, and 6-.

Courtesy of AUDI

-- Remove the main fuse panel -3-.