LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> SQ8 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 321 (Wiring) >> 97 Wiring >> Control Modules >> Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING >> Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, HIGH VERSION >> Removing

Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING, HIGH VERSION: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

The Data Bus on Board Diagnostic Interface -J533- is located under the left front seat.

-- Remove the left front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Remove the front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .

-- Lift the front carpet at the transition to the rear carpet.

-- Market-specific version: loosen the bolt.

-- Release the retainers -1-.

GWWA97-11906Courtesy of AUDI

-- Remove the data bus on board diagnostic interface -3- from the mount -2-.

-- Release and disconnect the connectors -6 and 7- and antenna wires -4 and 5-.