Telephone Baseplate -R126-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The Telephone Baseplate -R126- -1- is clipped into the storage compartment.

Courtesy of AUDI OF AMERICA, LLC

The rubber lip on the surface on which the Removal Tool for Coupling - Aerial:T40388 was inserted must be slightly pressed out.

-- Push the rubber lip using the Removal Tool for Coupling - Aerial:T40388 -A- carefully to the side and guide in the Removal Tool for Coupling - Aerial:T40388 vertically from above.

-- The catch -2- is released and engages in the groove on the Removal Tool for Coupling - Aerial:T40388 -A-.

-- Remove the Removal Tool for Coupling - Aerial:T40388 -A- vertically upward and remove the Telephone Baseplate -R126- -1-.

-- The Telephone Baseplate -R126- is clipped on the opposite side. Tilt the Telephone Baseplate -R126- -1- out of the storage compartment.

-- Disconnect the connectors.