Calibration Requirements: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- The camera lens must be clean.
- The vehicle must be standing on a firm and level surface.
- There must be sufficient open space around the vehicle.
- The parking brake must be set.
- The steering wheel must be in the 0 position and the wheels must be straight.
- All doors and the rear lid must be closed.
- No one should be in the vehicle.
- The vehicle must not be loaded (curb weight).
- Before each calibration: turn on the ignition.
The Calibration Unit:VAS6350A consists of the following parts:
- Calibration Tool - Wheel Center Mountings:VAS6350/1
- Calibration Tool - Spacing Laser:VAS6350/2
- Calibration Tool - Linear Laser:VAS6350/3