Chip Card Reader Control Module, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

The Chip Card Reader Control Module -J676- is located in the glove compartment, ER5.

Vehicles from Product Improvement

If the Chip Card Reader Control Module - J676- is replaced, the following procedure applies:

-- Connecting and switching on the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

Body
Electrical system
01 - OBD-capable systems
005F - Information Electronics Control Module 1 - J794 (MIB 3)
005F - Information Electronics Control Module 1, functions
0642 - Chip Card Reader Control Module -J676 replacing

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.

Continuation for All Vehicles