Left Rear Upper Body Vent Adjustment Motor -V315-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Audi SQ8, 2023 Audi RS Q8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Connector -A- And Adjustment Motor -C-

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

CAUTION:

There is a risk of damaging the adjustment motor electronics when turning the mount.

- Turn the adjustment motor mount only when the wiring harness is connected.

- Install the mount carefully and slowly by hand.

The actuator mount does not have a stop. It turns constantly if the actuator is activated. Therefore, it should not be activated when the actuator is removed.
Check the connection between the actuator mount and the shaft; there must not be any play.
The actuator -E- mount can only be installed in one position on the relay lever -D-.

-- Check the relay lever -D- and the mount of actuator -E-. They must be properly aligned so that they can be joined.

TIP

If the actuator mount -E- is not in the illustrated position (the connecting piece can only be installed in this position), install the connector -A- on the actuator -C- and turn the actuator mount -E- carefully to the position in which the two parts can be joined without pretension.

-- Ensure that the fastener -D- is in the correct installation position.

-- Install the actuator mount -E- onto the connecting element -D-.

-- Check the connection between the actuator -E- and the fastener -D-. There must be no play.

-- Install the bolts -B-.

-- Connect the connector -A-.

-- Install wiring harness -F- so that it cannot come in contact with any moving parts.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES FOR REMOVING AND INSTALLING ADJUSTMENT MOTORS .