Pneumatic System Compressor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Switch off the ignition.
-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the rubber fastener from the brackets on the compressor -1- -arrows-.
-- Press the safety catch -arrow A- to disconnect the connector -1-
-- Remove the pneumatic line -2- by lifting the safety catch slightly with a small flat-head screwdriver -arrow B-.