Lumbar Support With Air Cushions, Removing And Installing, Module With Valve Block 2 And Backrest Bolster Adjusters: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING .

Comfort Seat:

Courtesy of AUDI

-- Release and disconnect the connector -1- on the lumbar support valve block 2.

-- Unclip the wire -2- from the module carrier -arrows- and free it up.

-- Remove the bolt -3- for the module carrier.

Super Sport Seat:

Courtesy of AUDI

-- Release and disconnect the connector -1- on the lumbar support valve block 2.

-- Unclip the wire -2- from the module carrier -arrows- and free it up.

-- Remove the bolt -3- for the module carrier.

Continuation:

-- Remove the bolt -1-.

Courtesy of AUDI

-- Detach the backrest bolster adjuster -2- at the backrest frame -arrow- and free up the pneumatic line.

-- Repeat the procedure on the opposite side.

-- Pivot the module carrier -1- with the lumbar support air cushions forward, release it from the mounts -arrows-, and remove it with the backrest bolster adjuster -2 and 3-.

Courtesy of AUDI

-- Free up the pneumatic lines and thread them out.