Refrigerant Circuit Component Allocation, Influence On High And Low Pressure Sides: Condenser

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

The condenser diverts heat away from the compressed refrigerant gas to the surrounding air.

Fig 1: A/C Condenser

Courtesy of AUDI OF AMERICA, LLC

This condenses the refrigerant gas to fluid.

NOTE:

Depending on the refrigerant circuit design, the receiver/dryer can be installed (integrated) on the condenser or inside the condenser. Refer to Refrigerant Circuit (vehicle-specific Service Information) and the Parts Information.

The condenser is available in different versions and can only be differentiated by the part number on the outside. For version -1-, the condenser is divided into two areas "2 way condenser". For version -2-, the condenser is divided into four areas "4 way condenser".

Fig 2: Identifying Condenser With Fluid Reservoir Installed

Courtesy of AUDI OF AMERICA, LLC

This illustration shows a condenser with the receiver/dryer -C- installed.

The gaseous refrigerant enters at the connection -A- into the condenser. The refrigerant is then cooled inside the condenser and becomes fluid.

The liquid refrigerant collects in the receiver/dryer -C- (with dryer) and flows through the lower cooling area towards the connection -B-.

Depending on the design of the condenser (interior volumes, flow through, etc.), the refrigerant capacity in a refrigerant circuit may vary. Therefore always be sure of the correct version and allocation of the condenser. Refer to Refer to REFRIGERANT R134A CAPACITIES and the Parts Information.