Ignition Coils, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. Refer to the appropriate Service Information .

-- Remove the bolt -arrow- for the corresponding ignition coil.

Courtesy of AUDI

-- Insert the Puller:T10530 in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI

-- Turn the knurled nut -2- clockwise in direction of -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using the Puller:T10530 .

Fig 2: Identifying Puller T10530

Courtesy of AUDI