Door Arrester, Removing And Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

The following components must be replaced after removal. Refer to Overview - Door .

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.

Mandatory Replacement Parts

Bolts - Door Arrester

Removing

-- Move the door window into the "closed" position.

-- Remove the door trim panel. Refer to FRONT DOOR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the speaker. Refer to COMPONENT LOCATION OVERVIEW - SOUND SYSTEM .

-- Tape off the A-pillar in the door arrester area using adhesive tape, so that the paint will not be damaged.

-- Remove the door arrester bolt -arrow-.

Fig 1: Door Arrester Bolt

Courtesy of AUDI

-- Remove the bolts -arrows- and remove the door arrester -1- toward the inside.

Fig 2: Locating Door Arrester Bolts (Inside)

Courtesy of AUDI

-- Pull the cap -1- slightly to the side -A arrows- and remove it from the door arrester -2- -arrow B-.

Fig 3: Door Arrester Rubber Grommet

Courtesy of AUDI

Installing

Install in reverse order of removal and note the following:

Door arrester installation position. Refer to Figure.
Cap installation position. Refer to Figure.

Tightening Specifications

Refer to OVERVIEW - DOOR