Mounting Bracket, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Engage the operating cable in the operating lever on the mounting bracket. Refer to EXTERIOR DOOR OPERATING CABLE, REMOVING AND INSTALLING .
-- Bring the mounting bracket -2- into the installation position and on the outer door panel -1- -arrows-.
Further installation is performed in reverse order of removal, while noting the following:
- Equipped on some models: the wiring harness for the exterior door handle touch sensor/exterior door handle illumination must be routed on the mounting bracket, that points to the outer door panel.
NOTE:
If the wiring harness is not routed correctly, there may be noises when opening and closing the door window, because the door window grazes the wiring harness.