Lock Cylinder, Removing And Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Removing and installing the housing is performed the same way.
Removing
-- Remove the cap -arrow-.
-- Pull the door handle -1- all the way -arrow A- and hold it.
-- Remove the clamping screw -3- all the way using a screwdriver -5-
-- Push the retaining bracket -4- for the lock cylinder inward until it engages -arrow B-.
- The door handle is now locked in the "open" position.
-- Remove the lock cylinder -2- from the mounting bracket.
NOTE:
If the lock cylinder cannot be removed, push the ignition key in the lock cylinder and remove the lock cylinder with the key slightly turned.
Installing
Install in reverse order of removal and note the following:
-- Slide the lock cylinder into the mounting bracket and then check if the door lock closing and opening position functions.
Tightening Specifications