Assembly Mount Sensor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Assembly Mount Sensor 1 -G748- (Right)

Fig 1: Assembly Mounts Sensor Component Location

Courtesy of AUDI

-- Loosen the wheel housing liner in the area of the engine mount and push it aside. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the bolt -2- and remove the subframe mount sensor from above.

TIP:

Bolt is accessible from above.

-- Disconnect the connector -1- (example illustration).

Assembly Mount Sensor 2 -G749- (Left)

Fig 2: Assembly Mounts Sensor Component Location

Courtesy of AUDI

-- Remove the left drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Disconnect the connector -1- (example illustration).

-- Remove the bolt -2- and remove the subframe mount sensor from above.

TIP:

Bolt is accessible from above.