Wheel Housing Extension, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

• The vehicle and the cover must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.

-- Fold back the end of the protective film, or attach a pulling aid -3- to the protective film.

Courtesy of AUDI

-- Position the wheel housing extension -1- centrally on the wheel arch trim -2-.

-- Install the clamps -arrows- at the wheel housing extension -1-.

-- Remove the protective film on the pulling aids from the adhesive tape -3-.

-- Press on the wheel housing extension -1- in the adhesive surface area with the Roller:T40400  .

Continuation for All Vehicles:

• Vehicle resting time is at least 60 minutes at room temperature.