Rear Wheel Arch Trim, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the rear wheel housing liner from the retainer in the bumper cover area. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Release the catches -arrows- using needle nose pliers between the side panel mount -4- and the bumper cover -3-, and at the same time remove the wheel cover -2- from the bumper cover.
-- Carefully warm up the wheel arch trim using the Hot Air Blower:V.A.G 1416 .
-- Pry up the wheel cover with the Wedge Set :T10383/1 from the side panel -1- at the same time do not damage the paint coat.