Sill Panel Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film from the adhesive tape -1 and 3-.
-- Position the sill panel trim -2- over the pins on the side sill -arrows-.
-- Push the sill panel trim onto the side sill using the Roller:T40400 .
- Resting time approximately 30 minutes at room temperature
Further installation is performed in reverse order of the removal.