Rear Lid Trim Molding, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the left and right license plate lamp. Refer to LICENSE PLATE LAMP .
-- Remove the rear lid tail lamp. Refer to REAR LID TAIL LAMP, REMOVING AND INSTALLING .
-- Carefully warm up the center of the trim molding -1- using the Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A .
-- Release the retainers -arrows- and remove the trim molding -1- from the tail lamp -2- -arrow A-.