Rear Lid Trim Molding, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle and the trim molding must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film from the adhesive tape -2-.
-- Push on the trim molding until it engages audibly.
-- Press on the trim molding in the adhesive surface area with the Roller: T40400 .
- Resting time approximately 30 minutes at room temperature