Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
-- If the Electronic Steering Column Lock Control Module -J764- is replaced, then select the "Control Module, Replacing" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Remove the steering column from the instrument panel crossmember and place in the driver footwell with the steering intermediate shaft attached. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Switch the ignition on.
-- Remove the bolts -2-.
-- Push the tab -1- in the -direction of the arrow-. Remove the Electronic Steering Column Lock Control Module - J764- -2-.
-- Disconnect the connector from the Electronic Steering Column Lock Control Module - J764-.