Coupling Rod, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with active suspension: pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS WHEN WORKING ON VEHICLES WITH ACTIVE SUSPENSION .

-- Versions with coil springs: determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .

-- Versions with air suspension: determine the standard vehicle height. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Remove the front wheel. Refer to WHEELS AND TIRES .

Vehicles without Sway Stabilization:

Courtesy of AUDI

-- Install the Support Device:VAS 6931/1 -item A- to the brake rotor -1- using two wheel bolts -2-.

-- Position the Engine and Gearbox Jack:VAS 6931 -item B- on the support device.

CAUTION:

There is a risk of an accident when lowering or lifting the vehicle when the engine and gearbox jack is underneath it.

- Never lift or lower the vehicle when the engine and gearbox jack is underneath it.

- Never leave the engine and gearbox jack under the vehicle any longer than necessary.

-- Slightly lift the wheel bearing housing using the Support Device:VAS 6931/1 with the Engine and Gearbox Jack:VAS 6931 this allows the threaded connections to easily separate.

Continuation for All Vehicles:

Courtesy of AUDI

-- Disconnect the connectors -1 and 3- and remove the coupling rod -2-.

-- Vehicles without sway stabilization: remove the engine and transmission jack.

TIP:

Push the front wheels in accordingly if required to remove the lower bolt.