Suspension Strut, Removing And Installing: Notes

Special tools and workshop equipment required 

• Window Release Tool:T10236 

  Courtesy of AUDI

• Torque Wrench 1783 - 2-10Nm:V.A.G 1783  for versions with air suspension.
  Fig 1: Identifying Torque Wrench

  Courtesy of AUDI
• Torque Wrench 1783 - Open Jaw - 10mm:V.A.G 1783/1  for versions with air suspension.
  Fig 2: Identifying V. A. G 1783/1

  Courtesy of AUDI

Removing

-- Remove the shock absorber fork. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .

-- Remove the additional reinforcement for the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

Versions with Air Suspension:

Courtesy of AUDI

• Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
• Make sure that during the assembly work, no pressure points are created on the air suspension boot.
• If the air line is removed from a component, check if the cutting ring is seated on the air line.

-- Remove the air line -2- on the residual pressure valve -3-. The air escapes from this.

-- Free up the air line on the bracket -1-.

TIP:

The residual pressure valve cannot be removed separately.

-- Seal both connections.

-- Remove the cover -1-.

Courtesy of AUDI

-- Release the locking ring -2- upward -arrows-.

-- Press off the connector -1- using the Release Tool: T10236  -item 2-.

Courtesy of AUDI

Continuation for All Vehicles:

Courtesy of AUDI

-- Remove the bolts -arrows- and the suspension strut.

• Do not damage the CV boots on the steering, input shaft, and boot on the suspension strut.