Stabilizer Bar, Removing And Installing, With Sway Stabilization: Installing
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Minimum bending radius = 30 mm
-- Re-energize the 48 Volt system. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- After installation of a new stabilizer bar with sway stabilization, select the "Front Axle Sway Stabilization, Starting" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.