Overview - Stabilizer Bar, Without Sway Stabilization
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- Always replace after removing
- Remove and tighten evenly alternating from side to side.
- 55 Nm
- Clamp
- Stabilizer Bar
- with rubber bushing
- The rubber bushing cannot be replaced separately.
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITHOUT SWAY STABILIZATION .
- Nut
- Always replace after removing
- 40 Nm + 90°
- Subframe
- Bolt
- Always replace after removing
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Shock Absorber Fork
- Removing and installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
- Nut
- Always replace after removing
- 40 Nm + 90°
- Bolt
- Always replace after removing