OVERVIEW - STABILIZER BAR, WITH SWAY STABILIZATION /Sway Stabilization Control Module -J924- IN VEHICLE INTERIOR ON RIGHT A-PILLAR
WARNING: This page is about a different car, the 2024 Audi SQ8, 2024 Audi Q8, 2023 Audi SQ8, and 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Stabilizer Bar, With Sway Stabilization /Sway Stabilization Control Module -J924- In Vehicle Interior On Right A-Pillar
- Bolt
- Always replace after removing
- Remove and tighten evenly alternating from side to side.
- 55 Nm
- Clamp
- Bolt
- 8 Nm
- Nut
- 8 Nm
- Ground Wire
- Tightening specification. Refer to the appropriate Wiring Diagram.
- Wiring Harness to Stabilizer Bar with Sway Stabilization
- The wiring harness may not be separated from the stabilizer bar with sway stabilization. The connector must not be removed from the stabilizer bar with sway stabilization.
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- Always replace after removing
- Shock Absorber Fork
- Removing and installing. Refer to SHOCK ABSORBER FORK, REMOVING AND INSTALLING .
- Nut
- Always replace after removing
- 60 Nm +90°
- Bracket
- For Sway Stabilization Control Module -J924-
- Sway Stabilization Control Module -J924-
- Component location on vehicles with connector in the wiring harness in the vehicle interior on the center right A-pillar
- Removing and installing. Refer to Sway Stabilization Control Module -J924-, REMOVING AND INSTALLING .
- Bolt
- Always replace after removing
- Nut
- Always replace after removing
- 40 Nm + 90°
- Stabilizer Bar with Sway Stabilization
- With Left Front Suspension Stabilization Actuator -V634-
- With Right Front Suspension Stabilization Actuator -V635-
- with rubber bushing
- The rubber bushing cannot be replaced separately.
- When removing and installing the stabilizer bar with sway stabilization the wiring harness may not be removed from the stabilizer bar with sway stabilization. The connector must not be removed from the stabilizer bar with sway stabilization.
- Stabilizer bar with sway stabilization, removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING, WITH SWAY STABILIZATION .
- Bolt
- 20 Nm
- Bracket
- For the wiring harness
- Bracket
- For the wiring harness
- Wiring Harness to Sway Stabilization Control Module -J924-
- Bracket
- For connector
- Bolt
- 8 Nm
- Subframe